Dual-Holders Installation

Before you start, place your bike on a flat surface, lean on a kickstand or solid support, or mount it on a rear-wheel bike stand. Cover the rear wheel and seat stays with a towel to prevent scratches made by a falling hex key or screw.

  1. Holding two water bottles to determine which position will best fit your bike and riding position.
  2. Attach the MultiAngle (M.A.) Mount to the BASE Clamp.
  3. Put the BASE Clamp onto the seat post and half-tighten the 22mm locking screw.
  4. Half-tighten the Dual-Holders with 16mm screws at the holes on the M.A. mount of your preferred setting (See diagrams below for reference).
  5. Install bottle cages with 14mm screws onto the Dual-Holders.
  6. Insert water bottles into the cages.
  7. If the angle of the bottles and distance from the saddle are as expected, tighten the screws of the Dual-Holders to 2 Nm.
  8. Align the bottles and the mount to the rear wheel and tighten the locking screw of BASE Clamp to 3 Nm.

To try a different position:

  1. Remove water bottles
  2. Loosen the screws of the bottle cages but keep them stay on the Dual-Holders.
  3. Remove the 16mm screws of the Dual-Holders and test place the holder and cages on different spots.
  4. Secure the holders and cages when ready.